Dynojet Air Fuel Ratio Module - Manual (Page 10)

Air Fuel Ratio Module Installation and User Guide
C H A P T E R 1
Air Pump Assembly
1-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AIR PUMP ASSEMBLY
This section describes how to set up the Air Pump Assembly. Dynojet recommends
running the pump between dyno runs to help reduce the chance of moisture
contamination on the sensor. Always keep the pump in the upright position.
Refer to “Air Pump Maintenance and Troubleshooting” on page 2-7 for more
information.
P OWER R EQUIREMENTS
The Air Pump Assembly is supplied with either a 120 volt standard power plug or 240
volt European power plug. The current draw for both is less than 2.0 amps. Both
power plugs use a 3 amp 250 volt 5x20 mm fuse.
S TANDARD E UROPEAN P OWER P LUG
The Interpower™ Schuko power cord is suitable for use in Germany, Austria, Norway,
Sweden, Finland, the Netherlands, Belgium, France, Portugal, and Spain. You must
install the appropriate power plug specifically for your country to ensure proper
grounding.
S ETTING U P THE A IR P UMP A SSEMBLY
The Air Pump Assembly comes pre-assembled and ready to use.
1
Attach the power cord to an outlet.
2 Secure the sensor to the pump assembly.
3 Turn on the main power switch.
Figure 1-4: Air Pump Assembly
sensor
power switch
power cord plug
filter assembly