Dynojet 424xlc2: Pre-Installation Guide - Manual (Page 47)

D Y N O P R E - I N S T A L L A T I O N I N F O R M A T I O N
Unpacking The Dyno
Version 5 Pre-Installation Guide for Model 224 and 424 Automotive Dynamometers
39
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNPACKING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
You will need to provide equipment capable of lifting and moving the dyno. Refer to
“Forklift Requirements” on page 6 for more information.
R EMOVING THE C RATE T OP AND S IDES
1 Move the crated dyno to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate.
Note: At this point, you will want to inspect the exterior of the dyno for any
indications of damage. Report any damage immediately.
Figure 26: Removing the Crate Top and Sides