Dynojet 424xlc2: Pre-Installation Guide - Manual (Page 36)

Pre-Installation Guide for Model 224 and 424 Automotive Dynamometers
D Y N O P R E - I N S T A L L A T I O N I N F O R M A T I O N
In Ground Model 424x Dyno
28
R OOM L AYOUT —I N G ROUND M ODEL 424 X D YNO
Use the following information to locate the necessary dyno equipment, power outlets,
compressed air, and properly set up your dyno room.
For more detailed information about the pit requirements, refer to the pit
specifications (P/N 98219111) you received from your salesman.
Figure 17: Room Layout—In Ground Model 424x Dyno
584.20 cm (230.00 in.)
frame and covers full out
609.60 cm (240.00 in.)
out with bridge extension
469.90 cm (185.00 in.)
frame and covers full in
495.30 cm (195.00 in.)
in with bridge extension
229.87 cm
(90.50 in.)
161.54 cm
(63.60 in.)
provide 110V outlets for the:
•hydraulic motor
•computer
•monitor
•dyno electronics
locate the following items
close to the vehicle:
•dyno electronics
•computer
•monitor
AD442
provide compressed air:
•to release the air brake
•to run the AFR-4 air pump
pit conduits