Dynojet 424xlc2: Pre-Installation Guide - Manual (Page 12)

Pre-Installation Guide for Model 224 and 424 Automotive Dynamometers
D Y N O P R E - I N S T A L L A T I O N I N F O R M A T I O N
Specifications and Requirements
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SPECIFICATIONS AND REQUIREMENTS
The following specifications and requirements apply to all automotive dynos in this
manual. Take a moment to review the requirements and make sure you can provide
what your dyno will need.
C OMPRESSED A IR
The following requirements are needed for the air brake:
• Clean and dry air, between 100-140 psi
• shut off valve
• 1/4-inch NPT pipe thread connector (to attach air to the dyno), if air hose does not
have a 3/8-inch inside diameter
• have a 3/8-inch inside diameter
The following requirements are needed for the compressed air pump assembly:
• Clean and dry air, 100 psi regulated
• 5 CFM
• 1/4-inch NPT pipe thread connector (to attach air to the solenoid or pump ball
valve)
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software.
minimum system requirements recommended systems requirements
• Microsoft® Windows 2000/XP • Microsoft® Windows 2000/XP
• 800 MHz Processor • 2.4 GHz Processor or greater
• 256 MB of available RAM • 512 MB of available RAM or greater
• one 9-pin COM port, two 9-pin COM ports for
Tuning Link
• one 9-pin COM port, two 9-pin COM ports for
Tuning Link
• 1024 x 768, 256 color monitor (XGA) • 1280 x 1024 256 color monitor (SXGA) or better
• 1.2 gigabyte hard drive • 40 gigabyte hard drive
• 30 MB of available hard-disk space • 100 MB of available hard-disk space
• CD ROM • CD ROM
• printer, if hard copies are needed • printer, if hard copies are needed