Dynojet 224/4WD: Installation Guide - Manual (Page 22)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Inspecting the Dyno
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNPACKING AND INSPECTING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 1905 kg (4200 pounds) to move the crated dyno into
position in your dyno room. Refer to “Dynamometer Specifications and
Requirements” on page 1-4 for more information.
1
Move the crated dyno to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate.
Note: At this point, you will want to inspect the exterior of the dyno for any
indications of damage. Report any damage immediately.
3 Remove the grates, track assembly, and braces from the top portion of the crate
and set aside.
Note: For clarity, only two grates and one rail are shown in Figure 2-1.
4 Remove the parts and hardware boxes from the crate and set aside.
5 Remove the crate braces that supported the grates.
6 Before removing the dyno from the crate, you will need to install the track
assembly in your pit. Refer to the instructions page 2-3 for more information on
installing the track assembly.
# RECORD
Be sure you record the dynamometer number on the inside cover of this
manual.
Figure 2-1: Unpacking the Dyno
rail
(for clarity, not all parts to the
track assembly are shown)
dyno number
grates
(for clarity, not all
grates are shown)
crate brace