Dynojet 224/4WD: Installation Guide - Manual (Page 16)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 1
Dynamometer Specifications and Requirements
1-6
C OMPRESSED A IR
The following requirements are needed for the air brake:
• Clean and dry air, at least 100 psi
• shut off valve
• 1/4-inch NPT pipe thread connector (to attach air to the dyno), if air hose does not
have a 3/8-inch inside diameter
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software. WinPEP 7
includes complete documentation in online Help. From the WinPEP 7 menu bar,
choose Help
 WinPEP 7 Help or visit www.winpep.com.
E LECTRICAL R EQUIREMENTS
minimum system requirements recommended systems requirements
• Microsoft® Windows 2000/XP • Microsoft® Windows 2000/XP
• Pentium 800 MHz Processor • 2.4 GHz Processor or greater
• 256 MB of available RAM • 256 MB of available RAM or greater
• one COM port, at least one extra USB port • one COM port, at least one extra USB port
• 800x600, 256 color monitor (SVGA) • 1280x1024 256 color monitor (SVGA) or better
• 1.2 gigabyte hard drive • 1.2 gigabyte hard drive
• 30 MB of available hard-disk space • 100 MB of available hard-disk space
• CD ROM and floppy disk drive • CD ROM and floppy disk drive
• printer, if hard copies are needed • printer (preferably HP DeskJet®)
description specifications
Power Requirements 110v or 240v outlet
Frequency 50 or 60 Hz
Current: computer, optional air pump 120v 15 amp (combined load should be less than 10A)
Power Requirements: optional eddy
current brake
240v 30amp single phase circuit
refer to the Eddy Current Brake Installation and User
Guide for Model 224 Pit Automotive Dynamometers
(P/N 98215101)