Dynojet 250i: Control Panel Interface Upgrade (S/N 201xxxx) - Manual (Page 6)

4
7. On the back of the Power Distribution assembly you will need to remove three cables. These cables
will be re-used with the new Control Panel Interface/Power Distribution. Gently pull the quick lugs for
the two fan cables from the backs of the two circuit breakers. Make sure to only pull on the quick lug
and not on the wire. Loosen the barrier strip and remove the ground connections for the fan cables.
Leave the rest of these cables in the dyno as they will be installed on the new hardware.
Loosen terminals
and remove
ground wires Pull these quick lugs
Fan cables