Dynojet 200: High Pressure Blower - Manual (Page 9)

I N S T A L L A T I O N G U I D E
Installation
Version 3 High Pressure Blower Installation Guide
5
I NSTALLING THE H IGH P RESSURE B LOWER A SSEMBLIES
Repeat the following steps for each blower assembly.
Note: Make sure the motor on each blower is facing out (away from the dyno)
and that the intake is facing in.
1 Place a 1/8” thick poly washer around the pin on the blower assembly.
2 Insert the pin on the blower assembly into the blower arm.
Figure 3: Install the Blower Assemblies
blower assembly
1/8-inch thick
poly washer
blower arm
motor facing out
intake facing in