Dynojet 200: High Pressure Blower - Manual (Page 10)

High Pressure Blower Installation Guide
H I G H P R E S S U R E B L O W E R
Installation
6
P OWER H OOKUP
Each blower has its own power cord and will plug directly into the dyno chassis.
1
Plug the power cord from the blower into the power source located on the dyno
chassis.
2 Activate the blower using the switch on the blower motor. The blowers are
independent of one another; each blower can be turned on and off individually.
Risk of injury. Eye protection required. Be aware of debris from blowers. Be
sure the blowers are free and clear of any obstruction. The blowers can run at
any time once the cord is plugged into a power source.
Figure 4: Power Hookup
power cord
from blower
plug into
dyno chassis
power cord
from blower