Dynojet 188R: Eddy Current Brake - Manual (Page 7)

Document #98232100 5
Remove the Brake
Remove the existing dyno brake (if applicable).
Step 1
Remove the brake lines and master cylinder
assembly.
Brake Removal.
- Disconnect all air lines and brake lines from the
dyno.
- Disconnect brake electrical wires:
- Remove the cover on the wire terminal box
and disconnect the air valve wires from the
breakout board.
- Remove the four hex head bolts from
the air canister assembly and remove it.
The bolts come through from the other
side of the center frame section.
Remove the (4) hex
head bolts from the
other side of the
center frame section.