Dynojet 188R: Eddy Current Brake - Manual (Page 16)

14 Document #98232100
Step 5
Couple the retarder to the dyno.
- Put the bolt back in the torque arm and tighten
to 40 in. lbs.(4.5 N m). (Swivel the middle of
the retarder as necessary.)
- Slide the coupler on the dyno over the coupler
on the retarder so that the three holes in each of
the couplers line up.
- Bolt the couplers together with three 3/8"
coupler bolts and tighten to 396-444 in. lbs.
(45-50 N m).
- Tighten the set screws in the couplers to 260-
290 in. lbs. (29-33 N m).
Step 6
Bolt the retarder to the ground through the four
holes in the bottom lip. As shown below.