Dynojet 188R: Eddy Current Brake - Manual (Page 20)

18 Document #98232100
- The finished Breakout Board Wiring should
look like this:
Step 6
Run the Input Power Cable through the grommet
below the Control Box. (See picture on next page)
Control Cable
Temp Probe Cable
Data Acq. Cable
Note: The Eddy Current Brake is setup to run on
120 volts / 20 amps / 60 Hz for U.S. or 220
volts / 10 amps / 50 Hz for European
Note: The voltage source must be capable of
handling a minimum of 20 amps U.S. or
10 amps European.