Dynojet 188R: Eddy Current Brake - Manual (Page 23)

Document #98232100 21
Install The New Retarder Cover
Step 1
Remove the (4) screws that hold the cover on the
Wire Terminal Box.
Remove the cover on the wire terminal box and
set it aside.
Step 2
Using a small flat head screwdriver, loosen the
screws that retain the Starter Remote leads, and
pull the leads out of the box.
Step 3
Remove the wire restraint from the side of the
Retarder Cover. Unscrew the restraint into two
halves, then slide the Starter Remote leads
through the two halves. Using the plastic nuts,
secure the wires / restraint to the Retarder Cover.
See picture on next page.