Dynojet 188R: Eddy Current Brake - Manual (Page 22)

20 Document #98232100
Note: The Eddy Current Brake is setup to run on
120 volts / 20 amps / 60 Hz for US or 220
volt / 10 amps / 50 Hz for European.
Warning!! The voltage source and power plug must
be capable of handling a minimum of 20
amps. US or 10 amps European.
Step 9
Attach the Retarder Power Cable to the Control Box.
Step 10
Run the Retarder Power Cable along the edge of the
frame. Secure the wire with the wire loop you were
working with earlier.
Note: See Appendix A if you must change
the plug on the Input Power Cable.