Dynojet 188R: Eddy Current Brake - Manual (Page 19)

Document #98232100 17
- The jumpers circled in the picture (previous
page) may need to be changed to look like the
drawing below.
Step 5
Wire the Temperature Probe wires to the breakout
board.
- The temperature cable has 5 wires. They
connect to the wiring block on the bottom of
the breakout board labeled “ - TEMP- “.
The green wire connects to G1.
The white wire connects to W1.
The black wire connects to B1.
The red wire connects to R1.
The ground wire connects to S1.
See picture below.