Dynojet 188R: Eddy Current Brake - Manual (Page 27)

Document #98226100 Appendix A - 1
Appendix A
Note: The Eddy Current Brake is setup to run
on 120 volts / 20 amps / 60 Hz for US or
220 volt / 10 amps / 50 Hz for European.
Warning!! The voltage source and power plug must
be capable of handling a minimum of 20
amps. US or 10 amps European.
Clear Insulation Wire-
NEUTRAL
Black Insulation Wire-
HOT
Bare Wire-
GROUND
If you must replace the power plug, be sure to adhere to the
specification above. The individual wire descrptions are below: