DSS Networks 8261-RTM - Manual (Page 60)

Gigabit Ethernet Metro-Switch Board and Firmware Users Manual
DSS NETWORKS, INC. Version: 1.14g Page: 60
11. SPECIFICATIONS
Distance (copper): Recommended maximum distance is 328 feet (100 meters).
Backplane I/O: 12-ports routed to “J3” and “J5” Compact PCI connectors as per
PICMG 2.16 specification (RJ3 and RJ5 on rear I/O backplane).
NOTE: All J3 and J5 (RJ3, RJ5) pins must be fully PICMG 2.16 compliant or Passive or
electrical short circuit could occur.
Connectors (Rear I/O module):
10/100/1000 Base T connector type: RJ-45 (CAT5 specification)
Cable type (copper): CAT5, CAT5e or CAT6
Connector (Fiber, 1000 Base SX multimode):
LC type connector for 850nm VCSEL laser over 50 and 62.5 micron fiber
Connector (Fiber, 1000 Base LX singlemode):
LC type connector for 1310nm VCSEL laser over 9/125 micron fiber
Port Status Indicators: Link, Transmit, Receive and Signal Quality
Microcontroller Status Indicators: RUN, LINK STATUS, ERROR indicators
Bus Interface:
PCI v2.2 bus master, 32-bit, 33/66 MHz
Dimensions: Compact PCI 6U, 9.187 (H) X 6.300 (W)
PCI Power supply voltage: 5V power rail from CPCI J1 connector
PCI signaling voltage: 5V and 3.3V (5V tolerant)
Performance Throughput: 24 Gbps (full-duplex) sustained
Maximum frame rate: Up to 32 million frames per second total aggregate switching
rate (non-blocking)
Other: Jumbo packets, 802.3x full duplex flow control with
automatic pause and priority with multiple priority queues