DSS Networks 8261-RTM - Manual (Page 29)

Gigabit Ethernet Metro-Switch Board and Firmware Users Manual
DSS NETWORKS, INC. Version: 1.14g Page: 29
9.1.4 VLAN TABLE REGISTER COMMAND
The vlan table show register command is used to display the value of the corresponding
vlan register of the switch e.g., the register value which is used for the current mode of
operation.
metro-sw> vlan reg 3
vlan id = 03
vlan[0x3e00000]: 9 # value is (stg << 1) | valid_bit
vlan[0x3e0000c]: 1ff # egress_mapped_tagged port bitmap
vlan[0x3e00018]: 3ff # egress_mapped_untagged port bitmap
9.1.5 CFG SAVE COMMAND
metro-sw> cfg save
This command is used to save a previously defined configuration to eeprom so that it may be
loaded upon issuing a ‘switch reset’ command or upon power up.
Note: The ‘cfg save’ command affect only the switch configuration structure and does not affect
the individual ‘eereg set’ commands stored in eeprom. These are initialized and saved
independently via the ‘eereg set’ command.
9.1.6 CFG CLEAR COMMAND
metro-sw> cfg clr
This command is used to clear the configuration records prior to saving to eeprom thereby
erasing existing configuration.
Note: This command will clear the configuration and save the values to eeprom immediately.
No additional ‘cfg save’ command is necessary.
9.1.7 SWITCH RESET COMMAND
metro-sw> switch reset
This command is used to initiate a reset (reboot) of the switch.
Note: Any CLI configuration commands entered will be not saved unless a ‘cfg save’ command
is first issued prior to reset.
9.1.8 SETTING PACKET AGING
The ‘eereg set’ command is used to set packet aging as in the following example: