DSS Networks 8261-RTM - Manual (Page 32)

Gigabit Ethernet Metro-Switch Board and Firmware Users Manual
DSS NETWORKS, INC. Version: 1.14g Page: 32
The following table shows the encoding of the data bytes comprising the 32-bit longword
argument:
Bits
Name Description
30:28
FrameType
001 = Ethernet II
010 = 802.3 LLC/SNAP
100 = LLC
(Only one bit set per entry)
Frame type to match
Bits Name Description
27:12
EtherType (i.e. 0x0800 for
IPv4)
Ether type field which
determines the protocol
Bits Name Description
11:00
VLAN ID Vlan ID for this entry
9.1.11 ‘EEREG SET’ COMMAND
The ‘eereg set’ command is used to set
and enable certain features of the switch
functionality. For example :
metro-sw> eereg set 1 0x24 1 1 00 10 00 40
The parameters for the eereg set command are interpreted as follows:
metro-sw> eereg set
To show (display) all existing ‘eereg set’ entries:
metro-sw> eereg show
reg idx: 01, rclass: 01 (reg set cmd)
base: 24, strt/incr: 01, end/cnt: 01
data: 00 10 00 40
To clear out (erase) all existing ‘eereg set’ entries:
metro-sw> eereg set 0
Note: ‘eereg set’ commands are provided as a basic capability to set and enable certain
features of the switch functionality. Please contact our technical support department
regarding the setting of any additional features not shown in this document. The switch
must be reset after all reg-set commands have been entered in order to take effect.