BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 8)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 8
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
D. Locate the 2- 8mm x 20mm bolts, lock
washers, oil drain and oil drain gasket. Now
LOOSLEY bolt to turbocharger as shown, this
will make it easier to install the turbo to the oil
tank assembly bracket.
E. The center cartridge should rotate freely, rotate
the center cartridge so that the oil drain is on the
opposite of the exhaust inlet as shown in
picture.
F. Using assembly grease, liberally lubricate the
oil drain before installing the turbo into the oil
tank boot.
G. Insert the turbo onto the oil tank, align the
remaining 2 holes on the turbo housing with the
2 holes in the turbo mounting bracket as shown
in picture. Use the 2 provided 5/16 x ½” bolts
and tighten these first.
H. Tighten the remaining 4 bolts on the turbo
housing.
I. Tighten the 2 oil drain bolts, snug 1 bolt on
exhaust side of turbo housing.