BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 17)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 17
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
Step 10: Oil System
Parts Needed: Tools Needed:
Power adapter harness for oil pump None
4- 4” zip ties
A. Disconnect the factory fuel pump harness and plug in
the Boondocker adaptor harness.
B. Route the oil pump harness to the newly installed
molded connector.
C. Route the oil pump harness from the oil pump to the newly installed power adaptor. Zip tie
away from any sharp or moving objects.
Step 11:Exhaust Pipe
Parts Needed: Tools Needed:
Air saw or band saw
4- 8mm non Nylon lock nuts Welder
Stock pipe Basic tool kit
Boondocker turbo inlet Grinder or sand paper
4- 8mm x 25mm bolts
4- High tension exhaust springs
A. Remove stock heat shield from pipe.