BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 25)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 25
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
B. Fasten the oil tube to the bulkhead using the
factory bolt as shown.
C. Using the provided size 48 hose clamps, fasten the snorkel filter to the turbo inlet as
shown.
A. Fill oil tank with 16oz of synthetic 2 stroke
engine oil. IMPORTANT: start the sled to
make sure the oil pump is working before
installing it to the turbo.
B. Install the oil hose to the top of the turbo as
shown
C. Clean up and zip-tie all hoses.
D. Well you did it, good job. Replace the hood and side panels, oh yeah, and don’t forget
to hold on!!! Thanks for choosing Boondocker Performance Products.