BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 7)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 7
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
Step 4: Installing the Control Box
Parts Needed: Tools Needed:
Control Box w/instructions Basic tool set
A. SEE CONTROL BOX INSTRUCTIONS FOR INSTALLATION.
Step 5: Oil Tank/Turbo Assembly Bracket
Parts Needed: Tools Needed:
2-8mm x 20mm bolts Basic tool set
2- lock washers Assembly lube
3 hole drain gasket (packaged in turbo box)
Oil drain
Rubber grommet from stock muffler
2- rubber boot seals
2- 5/16 x ½” bolts
Turbocharger
Oil tank assembly bracket
A. Install the stock rubber grommet (removed
from the stock muffler in step 1) and install it
to the oil tank assembly bracket as shown in
picture. Install the 2 rubber boot seals as
shown in picture. Important: DO NOT
LUBRICATE THESE BOOTS.
B. Loosen the 6 exhaust housing bolts on the turbo.
C. Loosen the 4 bolts on the intake or compressor housing of turbo.