Salter Brecknell 1200 Series User Manual

Page 31

Model 122X MiniPrinter User’s Manual

Enlarged printing may be selected by sending both
the double height command (control code 14) and the
double width command (control code 15). The control
codes may be sent in either order, but because of the
double width restrictions, the codes should be sent at
the beginning of a line.

Example of Control Codes 14 and 15:

When the printer receives this control code it will
immediately reset the sequence number to 00000.

A standard character line is made up of ten dot lines.
Eight of these dot lines are used for the printable
character and two are used for space between lines.
When using character graphics it is desirable to
eliminate the two blank lines so the graphic charac-
ters connect together. Sending a CHR$(17) (control
code 17) anywhere on a line of data will stop the
printer from putting space between that line and the
next. If a CHR$(17) is not on a print line, the normal
space between lines will be printed.

Enlarged Printing

Codes 14 and 15

Example:

Run:

Reset Sequence Number

Code 16

Inhibit Line Spacing

Code 17