Salter Brecknell 1200 Series User Manual

Page 15

Model 122X MiniPrinter User’s Manual

With the printer in the setup menu and with
CONFIGURE [NEXT/OK] as the last item printed,
press OK (right side) to access the CONFIGURE
menu. The following is printed:

LOAD DEFAULTS gives you the opportunity to reset
the printer to all default settings (shown below).

Choose OK to do this or NEXT to go to the next
parameter. The following is printed:

Baud rate is the next parameter you can set in the
CONFIGURE menu. The complete list of parameters
and their possible values is shown below.

The sample list above shows the current baud rate is
1200. To accept this, press OK (right side) or view the
next baud rate value by pressing NEXT (left side).
Press OK when the baud rate you want is displayed.

Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200

DATA BITS is the next parameter. Choose the data
bit value the same way baud rate was chosen.
Choices are 7 or 8 data bits.

Baud Rate

Data Bits

Load Defaults

* The parallel interface
does not have these
selections.

The complete list of
defaults is shown in
the Default Table at
the end of this manual.