Salter Brecknell 1200 Series - Manual (Page 11)

Model 122X MiniPrinter User’s Manual 11
If your printer is used infrequently, the print impres-
sion may become weak because the ribbon has dried
out. To advance the ribbon to a new section, hold
down the Paper Feed switch for several seconds.
Below are the steps for replacing the ribbon:
1. Turn the printer offline.
2. Four small grooves are embossed on each side
of the printer cover. Push down on one or both
of these areas until the printer cover tilts.
3. When the printer cover is tilted up, lift it com-
pletely off.
4. Push down on the right side of ribbon cartridge
where it is marked “PUSH”. Remove the car-
tridge.
Changing the Printer
Ribbon