Salter Brecknell CP103 - Manual (Page 6)

4 CP103 Thermal Printer User Instructions
1.6 Signal Light Status
1.6.1 Power Light
1.6.2 Feed Light
1.7 Specifications
Power Light Light Color Printer Status Specification
Steady red light Red In the process of recharging battery
Red light blinks one time slowly every one second Red Battery power is low, recharge battery
Steady green light Green Battery voltage is good
Blinks between red and green light Red/Green Battery failure
Blinks 3 times between red and green light Red/Green Printing is finished or printer is in power on mode
No light None No power is detected
Feed light Light Color Printer status specification
Steady red light Red Feed paper or receiving data
Red light blinks quickly (2 times/sec) Red No paper
Red light blinks 3 times and then stops Red Printer parameter setting is finished and ok
Steady green light Green Printer status is ok but not connected bluetooth
Always alternating blink between red and green light Red/Green Printer dead, the buffer is full or temperature of
printhead is too high
Item Specification
Dimension (W×D×H) 104Ч75Ч48mm
Weight 145g (without battery and paper roll)
Print Width 58mm
Print Speed 90mm/s (MAX)
Memory 10K byte buffer and 8M byte flash
Interface RS-232 baud rate 4800 - 115200bps
Resolution 8 dot/mm (203dpi)
Language Support Figure, English characters, bit-image, bar code, curve
Character Size ANK: 12*24(dot), 1.5*3.0 (W*L, mm);
Chinese Character: 24*24 (dot), 3.0*3.0 (W*L, mm)
Print Commands ESC/POS compatible command set
Other Features Paper auto-detection, power detection, thermal protection, with machine charging, automatic sleeping mode
Working Conditions Temperature: 0° - 50°, Humidity 20% - 85%
Storage Conditions Temperature: -20° - 70°, Humidity 5% - 95%