Salter Brecknell CP103 - Manual (Page 15)

CP103 Thermal Printer User Instructions 13
4.2.2 Set the Printer Data Bits
Change the data bits of the printer to match the host device.
1. Go to the Testing tab.
2. Under the CMD Testing window (the top window) enter the following command
string:
+UART LEN:n
Where n is the number associated with the desired data bits
Note: Dont change the paramter if possible. If set n=1, must set parity of COM.
4.2.3 Set the Printer Stop Bit
Change the stop bit of the printer to match the host device.
1. Go to the Testing tab.
2. Under the CMD Testing window (the top window) enter the following command
string:
+UART STOP:n
Where n is the number associated with the desired stop bit
n Data Bits
0 8 bit (default)
1 9 bit
n Stop Bit
0 1 (default)
1 1.5
2 2