Salter Brecknell CP103 - Manual (Page 16)

14 CP103 Thermal Printer User Instructions
4.2.4 Set the Printer Parity
Change the parity of the printer to match the host device.
1. Go to the Testing tab.
2. Under the CMD Testing window (the top window) enter the following command
string:
+UART CRC:n
Where n is the number associated with the desired parity
NOTE: Only changed if the Data Bit has been changed to 9.
4.2.5 Restore Default Baud Rate
Set factory default baud rate.
1. Go to the Testing tab.
2. Under the CMD Testing window (the top window) enter the following command
string:
1f 40
3. Click on the box to the left of HEX.
4. Click the [SEND] button. The typed in command string will be displayed in the
bottom window if the command was sent.
n Parity
0 none (default)
1 even
2 odd