B&M 70441 HOLESHOT 2400 - Manual (Page 5)

verter installation will run warmer than
a lockup installation, and particularly
needs a transmission cooler.
6. TEMPERATURE GAGE (#80212) Most
transmission and converter failures are
traced directly to excessive heat. The
B&M transmission temperature gage
can save you a costly repair bill by warn-
ing you ahead of time of an overheating
transmission. The B&M temperature
gage is extremely accurate and depend-
able, it comes with all necessary hard-
ware and is easy to install.
7. TH700-R4 KICKDOWN KIT (70237)
The TH-700 has a hydraulic circuit that
causes a forced 4-3 down shift whenever
the throttle is opened past two thirds
travel. In some applications a forced 4-3
down shift is undesirable. After many
customer requests B&M has developed
an easily installed kit that will eliminate
the part throttle 4-3 down shift feature.
This kit does not alter normal shift
speeds or affect detent operation. This
kit is best installed along with B&M’s
70235 Transpak. It can also be installed
independent of other modifications, and
valve body removal is not required.
8. 4L60E SHIFTPLUS (#70380) For those
of you who have a 1993-1998 electroni-
cally controlled 4L60E, the SHIFTPLUS
is a great addition to firming up those soft
feeling factory shifts. With in a few min-
utes for installation, you can quickly and
simply increase your transmission line
pressure with just a flip of a switch. There
is no need to remove the transmission
pan to install the SHIFTPLUS. You trans-
mission will benefit from reduced wear
and slippage, which causes excessive
heat and can lead transmission life fail-
ure. You only need simple tools to install
and can easily go back to stock by simply
flipping a switch.
5
4L65E shown
Fig. 8
Electrical Connector
Trans cooler lines
w/retaining clips
2 Piece Bellhousing