B&M 40505 BRACKET AND LEVER KIT, 4R100/E40D - Manual

Installation Instructions
Bracket and Lever Kit
Ford E40D/4R100 Transmission
Part No. 40505
© 2012 B&M Racing & Performance Products
PARTS
SELECTOR SELECTOR CABLE
SHAFT LEVER BRACKET
M10 M10 SPACER
BOLT WASHER X2
M8 CABLE COTTER
BOLT SWIVEL PIN
X2
This B&M Bracket and Lever Kit allows any B&M Shifter to be used on a vehicle equipped
with a Ford E40D/4R100 automatic transmission. Both selector shaft and selector lever are
made of T6 Aluminum for strength and durability. To extend the life of this kit, the selector
shaft and the selector lever have been hard anodized to prevent wear and corrosion. Check
the parts and tools lists at the beginning of these instructions for the supplied parts and the
tools required to install your B&M Bracket and Lever Kit. Installation of the B&M Bracket and
Lever Kit can be accomplished by anyone with minimal mechanical experience.
INTRODUCTION
This B&M Bracket and Lever Kit can be installed in less than an hour by carefully following
the instructions. Read all instructions fi rst to familiarize yourself with the parts, tools, and
procedure.
9500879-00