B&M 10310 CAST ALUMINUM FRONT END COVER FOR DANA 30 IS CONSTRUCTED OF A356.0-T6 ALUMINUM. THIS RUGGED UNIT DIS - Manual

Instructions
Cast Aluminum Front End Cover
for DANA 30
(see www.bmracing.com for the latest vehicle fitment applications and model years)
Part Number 10310
© 2013 by B&M Racing and Performance Products
Printed in the USA 9500895-00
This B&M Cast Aluminum Front
End Cover has been designed to
work on most vehicles equipped
with a Dana 30 axle. The B&M Cast
Aluminum
Front End Cover
provides several advantages over
stock factory covers. The extra
capacity provides increased oil
volume and added cooling, while the
thick
aluminum construction
increases case rigidity. The
magnetic drain plug feature allows
regular gear oil changes without the
usual mess, and limits ferrous debris
from circulating in the axle.
INTRODUCTION
This cover can be installed in about
an hour by carefully following the
instructions. It is suggested that the
vehicle be allowed to cool off for a
few hours to avoid burns from hot oil
and parts. The vehicle should be off
the ground for ease of installation -
jack stands, wheel ramps or a hoist
will
work fine. MAKE SURE
VEHICLE IS FIRMLY SUPPORTED
- DO NOT WORK UNDER A
VEHICLE IF IT IS SUPPORTED BY
ONLY A JACK! Try to raise the
vehicle 1-2 feet so you will have
plenty of room to work. Also, have a
small box to put bolts in and a
drain pan to catch oil.
INSTALLATION
STEP 1. Clean axle housing cover
area from dirt and other debris.
NOTE: On some vehicles it
might be necessary to remove
some parts (e.g. sway bar,
panhard
rod) to make the
installation of the cover easier.
STEP 2. Place a drain pan
underneath the axle housing.
STEP 3 (OPTIONAL). Loosen the
fill plug with a
3/8” square ratchet
and extension. This is done as a
precaution; if stock cover needs to
be re-installed for any reason, there
will be no question whether the plug
is seized or cannot be removed.
STEP 4. Remove the 10 bolts
around the cover.
STEP 5. Carefully pry the cover