Transferring the captured image to pc, Troubleshooting – AVer CP135 user manual User Manual
Page 25
ENGLISH
22
T
T
r
r
a
a
n
n
s
s
f
f
e
e
r
r
r
r
i
i
n
n
g
g
t
t
h
h
e
e
C
C
a
a
p
p
t
t
u
u
r
r
e
e
d
d
I
I
m
m
a
a
g
g
e
e
t
t
o
o
P
P
C
C
This enables you to transfer the captured image from the built-in memory to PC.
The instruction below MUST be read and followed BEFORE connecting
the USB cable.
1. MUST set the USB CONNECTION as IMG DOWNLOAD before connecting the USB
cable.
To set the USB CONNECTION as IMG DOWNLOAD, press MENU > select USB
CONNECTION in SETTING menu list and press ENTER, select IMG DOWNLOAD
and press ENTER.
2. When “IMG DOWNLOAD” appears at the lower right corner of the presentation screen,
you may now connect the USB cable.
3. Upon connecting the USB cable, the system automatically detects the new removable
disk. You may now transfer the captured image(s) from the CP135 built-in memory to
PC hard disk.
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
This section provides many useful tips on how to solve common problems while using the
CP135.
There is no picture on the presentation screen.
1. Check all the connectors again as shown in this manual.
2. Check the on/off switch of the display output device.
3. Verify the setting of the display output device.
4. If you are presenting from a notebook or computer through the display output device, check the
cable connection from computer RGB (VGA) output to RGB input of CP135 and make sure
CP135 is in PC Mode.
I have set up the CP135 and checked all the connections as specified in the manual
but I cannot get a picture on the preferred presentation screen.
1. The unit POWER button turns orange in standby mode. Press the POWER button again to turn
on and the LED light will turn blue.
2. The default camera display resolution setting is on 1024x768. If your output device does not
support this resolution; no image can be projected. Simply press hold the MENU and
►
button to
the change the resolution setting.
3. If your display output device is on TV or any analog device, please switch the TV-RGB dip switch
to TV.
The picture on the presentation screen is distorted or the image is blurry.
1. Reset all changed settings, if any, to the original manufacturer default setting (Refer to the Menu
Functions for more details and steps).
2. Use the Brightness and Contrast menu functions to reduce the distortion if applicable.
3. If you discover that the image is blurry or out of focus, adjust the focus ring on the camera head.