AVer CP135 user manual - Manual (Page 23)

ENGLISH
20
OSD Menu Description
CAPTURE
SINGLE
CONTINUOUS
IMG SIZE
CONTINUOUS to save successive still images until the built-
in memory is full or when the CAP/DEL button is being press
again to stop.
In Continuous mode, press ENTER the bar will turn red, use
◄ & ► to increase and decrease the capture time interval
between frames and then press ENTER to save the setting
and the bar will turn white. The time interval can be set from 5
to 600 sec.
CAPTURE
SINGLE
CONTINUOUS
IMG SIZE
5 SECS
INTERVAL
In IMG SIZE, press ENTER, use ▲ and ▼ to make a
selection, and press ENTER to save the setting.
CAPTURE
SINGLE
CONTINUOUS
IMG SIZE 1024 x 768
2016 x 1520
NIGHT VIEW
OFF
AUTO
IMAGE > NIGHT VIEW
Use ▲or▼ to turn Night View OFF or AUTO.
If you are presenting in a low-light condition, Night View
enables the image of the object to appear as though under
normal lighting conditions. CP135 can automatically adjust the
exposure to compensate for the adverse condition, but the
captured image will appear to be in slow motion.
CONTRAST
255 0 128
SETTING > CONTRAST
Use ►or◄ to emphasize or reduce the difference between
light and dark conditions then press ENTER. The contrast
level can be adjustable up to 255.
BRIGHTNESS
63 0 32
SETTING > BRIGHTNESS
Use ►or◄ to increase or decrease the brightness level and
improve the visibility of the image then press ENTER. The
brightness level can be set up to 63.
FORMAT MEMORY
NO
YES
SETTING > FORMAT MEMORY
Use ▲or▼ to select NO to exit or YES to format and delete all
the images saved in the built-in memory then press ENTER.
Please wait till the message “FORMAT” at the lower right
corner of the screen disappear to finish the process.
RESOLUTION
1024 x 768
800 x 600
640 x 480
1280 x 720
SETTING > RESOLUTION
Use ▲or▼ to choose from different supported display
resolutions then press ENTER to make the selection.
This selection will be disabled in TV output mode.
LANGUAGE
ENGLISH
ESPAÑOL
日本語
繁體中文
SETTING > LANGUAGE
Use ▲or▼ to select from different supported languages then
press ENTER to make the selection.