Canon DR-5060F - Manual (Page 80)

78
Patch Code Settings
Make the settings for scanning patch codes (See P. 47) and function sheet
patterns (See P. 49). These settings are enabled when the optional patch code/
function sheet detector is attached.
◆ Area
Specify the area in which patch codes and function sheet patterns are to be
scanned.
[Maximum Area]
If you mark this check box, patch codes and function sheet patterns in the area
shown below will be scanned in the original feed direction. If this check box is
not marked, you can enter start and end points to specify a specific scan area
within this area.
5 mm (0.2 in.)
94 mm (3.7 in.)
5 mm (0.2 in.)
5 mm (0.2 in.)
[X Offset Start]
Enter the scanning start point on the X-axis (horizontal direction) referenced to
the left edge of the document entrance in the feed direction in millimeters
(mm).
[X Offset End]
Enter the scanning end point on the X-axis in millimeters (mm).
Feed direction
Setting Scan Conditions