Canon DR-5060F - Manual (Page 57)

55
Setting Detailed Scan Conditions
3
Detailed Settings
Image Controls
The Image Controls panel is for setting margins around images to be scanned,
settings for the backside of documents, and filters.
Margin Scanning
Adjust the scan area at the top, bottom, left and right of the page size set at Page
Size (See P. 24).
Adjust the scan area by marking the [Enabled] check box and adjusting within the
range –10 (scan with 10 mm (0.39 in.) less margin) and +10 (scan with 10 mm
(0.39 in.) more margin).
MEMO
● To scan without clipping the edges of the scanned image, adjust this setting
in the + direction to expand the scan area. To scan so that there is no black
margin around the scanned image, adjust in the – direction to restrict the
scan area.
● The maximum width of the scan area is 297 mm (11.5 in.). Areas outside of
this maximum scan area of 297 mm (11.5 in.) after margins are adjusted are
not scanned.
Scan area
(margin set to + direction) Scan area
(margin set to – direction)