How to use the trigger grip – Canon CINEZOOM 512 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE THE TRIGGER GRIP
While
holding
the
grip,
operate
the
shutter
release
and
electric
zooming.
For
electric
zooming, load two batteries.
Zooming
switch
iLock lever
Shutter
operating pin
Zooming operating pin
battery
ATTACHING ONTO THE CAMERA BODY
1. Turn the lock lever in the direction of the
arrow.
2.
Fit the 3 contact sections, and tighten
with the tripod screw.
HOW TO LOAD THE BATTERY
Unscrew
the
cover
at
the
bottom
of
the
grip,
and
insert
the
battery,
being
careful
not to mistake the + and —.
STORAGE AND USE
Hold
the
grip
with
the
right
hand.
When
the trigger is pulled, the shutter is reieased
and when the zooming switch is turned on,
zooming is performed electrically.
• With a new battery.
• When the camera is not used for about
six months, aiways remove the battery.
•
When using the grip, check the electric
voitage.
• Operation is possible even when the Tele
Converter is attached.
•
Zooming time from wide angle to tele
scopic is about five seconds.
• Since the iock lever is a safety device for
shutter
and
zooming,
when
the
camera
is not in use, aiways turn it in the direc
tion of the arrow.