Inserting new lithium battery, Inserting new littiium battery – Canon E 200 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

18
Inserting New Lithium Battery
The CR2025 type lithium battery provides your
camera with enough power to store the date
and time and a character title, even when the
camera is turned off.
One lithium battery will last approximately one
year. (Life span of lithium battery varies slightly
according to ambient conditions.) When the
iithium battery is not in place or is nearly
exhausted, “DATE” flashes in viewfinder,
indicating that the iithium battery needs to be
replaced. |EQ
Be sure to connect a power source to the
camera before changing the lithium battery,
othenvise, the date and time and a character
title will be cleared from camera’s memory and
will have to be reset.
Inserting Procedure
1. Press GRIP UNLOCK button and
rotate the grip downward.
2. Hold the camera with the battery
pack facing down, then draw out
the lithium battery holder.
• If the camera is held with the battery pack
facing up, the lithium battery will drop out
when the lithium battery holder is removed.
3. Insert a new lithium battery into
the lithium battery hoider with +
side facing up.
Snap the lithium battery holder
into the compartment.
Warning
□
The battery used in this device may present a fire or
chemical bum hazard if mistreated. Do not recharge,
disassemble, heat above 100°C or incinerate.
Replace battery with Panasonic CR2025 or Duracell
DL2025B. Use of another battery may present a risk
of fire or explosion. The used battery should be
handed back to the supplier for safe disposal.
Caution
----------------------------------- ----------------
• Make sure
+
side is facing up in lithium battery
compartment.
• Keep battery out of children's reach. If swallowed,
contact physician immediately.
• To ensure proper contact, wipe battery with dean,
dry doth before use.
• Do not pick up battery using tweezers or other
metal tools which may cause short drcuiting.
• Do not disassemble, heat or immerse in water, to
avoid risk of explosion.