To remove the battery pack, Notes on charging the battery pack, Installing the battery pack – Sony CCD-TR910 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Note on remaining battery time indication during recording
When you use the InfoLITHIUM battery pack, remaining battery time is displayed in
the viewfinder. However, the indication may not be displayed properly, depending on
using conditions and circumstances.
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
•
Tbie CHARGE lamp will remain lit for a while even if the battery pack is removed and
the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, discormect the power cord. After about one
minute, reconnect the power cord again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
• When a fully charged battery pack is installed, the CHARGE lamp will light once,
then go out.
installing the battery pack
Align the prongs of the battery pack with the receptacles of the camcorder and slide the
battery pack down until it catches on the battery release lever and clicks.
To remove the battery pack
While pressing the battery ВАТТ (battery) PUSH button, slide the battery pack in the
direction of the arrow.