To change the end point, Note on the inserted picture, Replacing recording on a tape (insert – Sony CCD-TR910 User Manual

Page 55: Editing) (ccd-tr910 only)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Replacing recording on a tape (insert editing) -;7CCD-TR910 only

You can insert a new scene from a VCR onto your originally recorded tape by
specifying starting and ending points.
Connections are the same as in "Recording from a VCR or TV" on the previous page.
(1)

In the menu system, make sure that the item of COUNTER is set to NORMAL. While

pressing the small green button on the POWER switch, slide it to VTR.

(2)

On the VCR, locate the start point to be inserted and set it to playback pause mode.

(3)

On the camcorder, locate the point where the insert should end by pressing

then press II to set it to playback pause mode.

(4)

Press COUNTER RESET to set the counter to zero.

(5)

On the camcorder, locate the point where the insert should begin by pressing

then press • REC and II to set it to recording pause mode.

(

)

Press ZERO MEM on the Remote Commander. The ZERO MEM indicator flashes

and the end point of the insert is stored in memory.

(7)

Press II on the camcorder and the VCR simultaneously to start insert editing. The

insert editing stops automatically near the counter's zero point.

■a

To change the end point

Press ZERO MEM on the Remote Commander so that the ZERO MEM indicator
disappears and begin from step 3.

Note on the inserted picture

The picture may be distorted at the end of the inserted portion when it is played back.