Sony CCD-TR910 - Manual (Page 67)

Operation
Symptom Cause and/or Corrective Action
START/STOP does not operate. • The tape is stuck to the drum.
Eject the tape, (p.9)
• The tape has run out.
Rewind the tape or use a new one. (p.l7)
• The POWER switch is set to VTR.
Set it to CAMERA. (p.lO)
• The tab on the cassette is out (red).
■¥ Use a new tape or slide the tab. (p.9)
The cassette carmot be removed
from the holder. »The battery is dead.
Use a charged battery pack or the AC power adaptor.
(p.6,20)
51 and ^ indicators flash and no
function except for cassette
ejection works. ' Moisture condensation has occurred.
Remove the cassette and leave the camcorder for at least 1
hour, (p.9)
The counter, date, or time
indicator is flashing. • You pressed DATE and TIME together for more than 2 seconds.
■ > The camcorder is not malfunctioning. You may start
recording. Flashing will stop soon.
• The lithium battery is weak or dead.
-> Replace the lithium battery with a new one. (p.56)
>
a.
The tape does not move when a
tape transport button is pressed. • The POWER switch is set to CAMERA or OFF.
Set it to VTR.
• The tape has run out.
-> Rewind the tape or use a new one. (p.l7)
The date or time indicator
disappears. • Reset the date and time, (p.57)
The Steady Shot function does
not activate. • STEADY SHOT is set to OFF.
-> Set STEADY SHOT to ON. (p.35)
• The Steady Shot function does not work when the wide mode
is set to 16:9 FULL.
Set another mode, (p.26)
The autofocusing function does
not work. • FOCUS is set to MANUAL.
-> Set-it to AUTO. (p.30)
• Shooting conditions are not suitable for autofocus.
Set FOCUS to MANUAL to focus manually. (p.30)
No sound or only a low sound is
heard when playing back a tape. ' The stereo tape is played back with HiFi SND set to 1 or 2 in
the menu system.
Set to STEREO in the menu system, (p.24)
FADER does not activate. • The START/STOP MODE switch is set to 5 SEC or
Setitto y. (p.42)
• A title is displayed.
Stop superimposing the title.
Recording stops in a few
seconds. > The START/STOP MODE switch is set to 5 SEC or A.
Set it to M. (p.42)
Excessive high-pitched sound is
heard. > The picture has been recorded with WIND set to ON in the
menu system.
When there is no wind, set it to OFF. (p.23)
67