Sony CCD-TR910 - Manual (Page 20)

Using alternative power sources
You can choose any of the following power sources for your camcorder: battery pack,
and the house current. Choose the appropriate power source depending on where you
want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack InfoLlTHIUM battery pack NP-F530 (supplied), NP-F730
Note on power sources
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply again
immediately.
Using the house current :
To use the supplied AC power adaptor:
(1) Cormect the AC power cord to a wall outlet.
( 2 ) Slide the connecting plate down into the guides at the rear of the camcorder until it
clicks.
Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the VTR/CAMERA lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord.
To remove the connecting plate
Pull out the connecting plate by the plate. Never pull the connecting cord itself.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the wall outlet, even if the set itself has been turned off.
20