Sony CCD-TR910 - Manual (Page 66)

Trouble check
If you run into any problem using the camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, discormect the power source
and contact your Sony dealer or local authorized Sony service facility.
Camcorder
Power
Symptom Cause ano'/ui Corrective Action
The power is not on. •
The battery pack is not installed.
Install the battery pack, (p.7)
• The battery is dead.
Use a charged batteiy pack, (p.6)
•
The AC power adaptor is not connected to the wall outlet.
Connect the AC power adaptor to the wall outlet. (p.20)
• Some accessories are attached to the camcorder when the
battery pack is weak
Use a charged battery pack, (p.6)
• You use other types of battery except NP-F530/F730.
The power goes off. • While being operated in CAMERA mode, the camcorder has
been in Standby mode for more than 5 minutes.
■>
Turn STANDBY down once and then up again. (p.lO)
•
The battery is dead.
■>
Use a charged battery pack, (p.6)
The battery pack is quickly
discharged.
•
The ambient temperature is too low. (p.6)
•
The battery pack has not been charged fully.
■>
Charge the battery pack again, (p.6)
•
The battery pack is completely dead, and cannot be recharged.
•>
Use another battery pack, (p.7)
•
The battery pack is discharged during a long period of storage.
->
Charge the battery pack again, (p.6)
•
You use other types of battery except NP-F530/F730.
The beep sounds when the
battery is attached •
The battery pack is discharged during a long period of storage.
■>
Charge the battery pack again, (p.6)
When you turn off the power,
the lens makes a noise.
•
The camcorder is not malfunctioning.
66