Sony CAV-1 - Manual (Page 15)

Preparation
Preventing Interference
~When Using Two or More
Air-EGGs (CAV-1 Only)
If you use two or more CAV-1 at the same
time, interference between the RF signals may
occur, causing the interface boxes to operate
erratically. To prevent this, vou can give each
Air-EGG a unique identification (security
setting) to allow RF signals from one Air-
EGG to be distinguished from those of
another. Follow the procedure below to
assign a security setting to each Air-EGG.
1
Open the battery compartment on the
Air-EGG and remove the batteries.
You will see a set'of security switches as
shown below.
Security switches
2
Set the security switches.
Use a pointed object to flip up each
switch according to the security setting
to be assigned to that Air-EGG,
3
Set the security switches on the front-
right of the interface box to the same
security setting as its Air-EGG.
Installing the CD-ROM
Control Software
To install the CD-ROM control software, your
computer's operating system must be version
7.1 or later (for a Macintosh), or Windows 3.1
or later (for an IBM-compatible PC).
Use of the Air-EGG as a mouse substitute,
however, does not require installation of the
control software.
1
Turn on the computer and the interface
box (CAV-lOR/CAV-lOE).
2
Insert the CD-ROM into your CD-ROM
drive.
The icon for installing the software
appears.
(Continued)
15