beautypg.com

Manufacturer code numbers (cable box), Manufacturer code numbers (satellite receiver), To operate the projection tv – Sony KP 61S70 User Manual

Page 49: Setting the manufacturer's code, Operating a cable box or satellite receiver (sat)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Operating a Cable Box or Satellite Receiver (SAT)

Setting the Manufacturer's
Code

You Ccin progiMin tlio suppliod remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.
Eor exam pie, to operate a Sony satellite recei\'er:

CODE SET SAT/CABLE

^

Manufacturer

code

numbers

(cable box)

Manufacturer

Code

Hamlin/Regal
Jerrold/G.l

Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith

222, 223, 224, 225, 226

201,202,203,204,205,

222, 206, 207, 208, 218‘

227, 228, 229

219, 220, 221

214, 215

209, 210, 211

216, 217
212, 213

Manufacturer

code

numbers

(satellite receiver)

Manufacturer

Code number

Sony

801 (preset code for

remote control)

General Electric

802, 808

Hitachi

805

Hughes

804

Panasonic

803

RCA/PROSCAN

802

Toshiba

806, 807

To operate the cable box or

satellite receiver (SAT)

1

Press SAT/CABLE (POWER) [Green

Button] to turn on/off the cable box or
satellite receiver.

Press SAT/CABLE (FUNCTION).

For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
receiver.

2

3

If the remote control doesn't work

• Try repeating the set up procedures using

the other codes listed for your equipment.

To operate the projection TV

Press TV (FUNCTION). Then use the
projection T\' control buttons to control the
projection T\'.

Tip,

V

If imur llhiii oiw code number Ì, Hik’d, In/ eufcriiig

Ihciii one by one until you conic lo the correct code

tor your equipment.

If you enter a new code number, the code number

tfou prcviouily entered ut tliut setting is erased.

In some rare cases, you may not be able to operate

your equipment with the supplied remote control. In

this case, use the equipment's own remote control

unit.

Whenever you remove the batteries

to replace

them, for example

if too much time is taken, the

code numbers may revert to the factory setting and

must be reset.

45

This manual is related to the following products: