Compaq P5000 Series - Manual (Page 46)

46
Chapter 2 Install Basic Components
Figure 38. Raising the Forms Thickness Lever
3. Raise the forms thickness lever as far as it will go. This allows you to turn
the vertical position knob freely in order to align the top-of-form.
Figure 39. Aligning the Top-of-Form
4. Locate the TOF indicator. It is the small tab located on the tractor doors.
5. Turn the vertical position knob to align the top of the first print line with the
TOF indicator.
Forms Thickness
Lever
TOF Indicator
Perforation
Vertical Position
Knob