Other operations – Sony STR-DB940 User Manual

Page 85

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

other Operations

Using the auto power function

With the auto power function turned on, the commander

sends numerous codes to the appropriate Sony AV
components when you select a video function

Automatically, the components and the TV you have done

IR setting turn on and the TV switches to the selected
input mode This function works for Sony components

only

Press SET UP.

The set up list appears

Move the easy scroll key to select "AUTO POWER",

then press the key to enter the selection
The AUTO POWER list appears

Move the easy scroll key to select "BACK LIGHT,"

then press the key to enter the selection
The BACK LIGHT list appears

Move the easy scroll key to select "ON" or "OFF",

then press the key to enter the selection

When you select "ON", move the easy scroll key to
select the video input of the TV, then press the key

to enter the selection

^TU-UIDE01

TU-UIDE02
TU-UIDE03

Note

Switching to VIDEO 1~4 input may not be automatic on all Sony

TVs This is because some TVs cannot receive remote control

codes immediately after being turned on

liurning the backlight on or off

Each time you press a button on the remote, the backlight
turns on If you do the procedure below to turn off the

backlight, you can make the batteries last longer

Press SET UP.

The set up list appears

Move the easy scroll key to select "ON" or "OFF,"

then press the key to enter the selection.

Adjusting the contrast of the display

You can adjust the contrast of the display

Press SET UP.

The set up list appears

Move the easy scroll key to select "CONTRAST",

then press the key to enter the selection

Move the easy scroll key to select"+" or then

press the key to enter the selection

To cancel adjusting

Select "EXIT" in step 3

Clearing all the contents of remote's

memory

Be sure to turn on the receiver and point the remote

towards the receiver when performing the following

procedure

Press SET UP.

The set up list appears

Move the easy scroll key to select "ALL CLEAR",

then press the key to enter the selection

Move the easy scroll key to select "YES", then press

the key to enter the selection

"CLEAR OK?" appears

Move the easy scroll key to select "YES" again,

then press the key
All the contents of the remote's memory (i e, all the
programmed data) are cleared