Selecting a sound field, 2ch stereg ^a.f.d. analog direct normal surround – Sony STR-DB940 User Manual

Page 79

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Selecting a Sound Field

If you selected the tape deck

Move the easy scroll key to display the information about

deck A or B

Note

When the remote is programmed to control a non-Sony tape

deck, the following may occur:

— The information about deck B is not displayed and you

carmot switch between tape deck A and B

— "TAPE A / B" is displayed and tape deck A and B switch

automatically each time you press the easy scroll key, etc

If you selected the 2ND AUDIO source

Move the easy scroll key to select the source of 2ND
AUDIO, then press the key

Note

Depending on the component you are using, "2ND AUDIO" may

not be displayed

Do the procedure below to select a sound field from the

sound field list Note that the sound fields contained in

each list will vary depending on the receiver

Press SOUND FIELD

The sound field list appears

2CH STEREG

^A.F.D.

ANALOG DIRECT

NORMAL SURROUND

Move the easy scroll key to select the sound field,

then press the key to enter the selection

A display example

NORMAL SURROUND
CINEMA ST.EX.A
CINEMA ST.EX.В

^CINEMA ST.EX.C

To turn off the sound field

Move the easy scroll key to select either "2CH STEREO"

or "A F D " in the sound field lisf in the display The

sound field list that is displayed is different depending on
the model