Sony STR-DB940 - Manual (Page 45)

Direct Tuning
Use the supplied remote to perform the following
operations For details on the buttons used in this section,
see the operating instructions for the supplied remote
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in
2 Press FM/AM to select the FM or AM band
3 Press D TUNING
4 Press the numeric buttons to enter the frequency
Example!: FM 102 50 MHz
Example 2: AM 1350 kHz
(You don't have to enter the last "0" when the tuning scale is
set to 10 kHz )
®*®-®-®
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency If not,
repeat Steps 3 and 4
If the entered numbers still flash, the frequency is not
used in your area
5 If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception
6 Repeat Steps 2 to 5 to receive another station
9 If you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down
The tuning scale for direct tuning differs depending on the area
code as shown in the following table For details on area codes,
see page 3
Area code FM tuning scale AM tuning scale
U, CA 50 kHz 10 kHz
(can be changed to 9 kHz)*
AU, CN, SP, CED 50 kHz 9 kHz
* To change the AM tuning scale, see page 60
Automatic Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 44
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in
2 Press FM/AM to select the FM or AM band
3 Press TUNING (PTY SELECT) + or TUNING (PTY
SELECT)-
Press the + button to scan from low to high; press the -
button to scan from high to low
The receiver stops scanning whenever a station is
received
When the receiver reaches either end of the
band
Scanning is repeated in the same direction
4 To continue scanning, press TUNING (PTY SELECT) +
or TUNING (PTY SELECT) - again
45
(P
A
<‘
s'
09
0
ai
a
A