Sony DCR-TR7000 - Manual (Page 39)

Inserting a scene
You can insert a scene in the middle of a recorded tape by setting the start and end
points. The previously recorded frames between these start and end points will be
erased. Use the Remote Commander for this operation.
^ (al 4^ [b]
(1) While your camcorder is in the standby mode, keep pressing EDITSEARCH,
and release the button at the insert end point [b].
(2) Press ZERO SET MEMORY. The ZERO SET MEMORY indicator flashes and
the tape counter resets to zero.
(3) Keep pressing the - @ side of EDITSEARCH and release the button at the
insert start point [a].
(4) Press START/STOP to start recording. The scene is inserted. Recording stops
automatically at the tape counter zero point. Your camcorder returns to the
standby mode.
EDITSEARCH
>
Î
3
i
»
«
o
■*
Notes
• The zero set memory function works only for tapes recorded in the DigitalS H system.
• The picture and the sound may be distorted at the end of the inserted section when it
is played back.
If you re-record on the section which contains a non-recorded section
The zero set memory function may not work correctly.
When START/STOP MODE is set to
1.
or 5SEC
You cannot use the zero set memory function.
39